Simrad SX90 - INSTALLATION REV C - Connect the Ethernet Cable for Scientific Output; Connect Cable to External Audio System

Cablelayoutandinterconnections
ConnecttheEthernetcableforscientic
output
Procedure
ThisiscableSX90/C32.
1
ConnecttheEthernetcablefromtheadditionalEthernet
socketontherearsideoftheProcessorUnit.
Note
Thiscablemustbeprovidedbytheinstallationshipyard.
UseacommercialCAT–6cable.
2 TerminatetheotherendoftheEthernetcableina
suitableaccesspointfortheship’snetwork.
Relatedtopics
•RJ45Ethernet,straightonpage208
Connectcabletoexternalaudiosystem
Procedure
ThisiscableSX90/C18.
Acommercialcableisused.Oneendmustbeterminatedwith
a“mini-jack”.Theotherendmustbeterminatedtomatchthe
audiosysteminput.
1
Connecttheaudiocablefromtheaudiooutputsocket
ontherearsideoftheBeamformerUnit.
Theoutputsocketisidentiedwithagreenring.
Figure38The(A)identiestheaudiooutputontherear
sideoftheBeamformerUnit
2 Terminatetheotherendoftheaudiocabletota
suitableinputonthesoundsystem.
Relatedtopics
•Commercialcablewithmini-jackonpage196
307531/C
89