Simrad SX90 - INSTALLATION REV C - Page 137

Interfacingperipheralequipment
2OntheI/OSetupmenu,selectSensors→Speed→SpeedLog.
3ObservethattheSensorCongparameterdialogappearsat
thebottomofthemenueld.
4CheckthatthesettingsintheSensorCongparameterdialog
correspondtothesensorsettingstable.
Note
Thepulselogmustuseserialportnumber9.
5ClickClosetoexittheSensorCongparameterdialog.
6Checkthatthespeedread-outintheStatusparameterdialog
correspondstothereadingfromthevessel’sspeedlog.
Speedlog(RS-232seriallineinterface)
Observethefollowingproceduretosetupandtestthespeed
loginput.
1AccesstheI/OSetupmenu.
•Toaccessthismenu,seeHowtochangetheinterface
settingsonpage129.
2OntheI/OSetupmenu,selectSensors→Speed→SpeedLog.
3ObservethattheSensorCongparameterdialogueappears
atthebottomofthemenueld.
4ChangethesettingsintheSensorCongparameterdialogue
tosuityourrequirementsfortheserialline.Rememberto
setcorrectbaudrate,andsetTalkertoNone.
5ClickClosetoexittheSensorCongparameterdialogue.
6Checkthatthespeedread-outintheStatusparameter
dialoguecorrespondstothereadingfromthevessel’sspeed
log.
(D)GPSspeeddata(RS-232seriallineinterface)
IftheGPSisusedforthespeeddatainput,waitwiththistest
untiltheGPSpositiondataaretested.Whenrequired,observe
thefollowingproceduretotesttheGPSspeedinput.
1AccesstheI/OSetupmenu.
•Toaccessthismenu,seeHowtochangetheinterface
settingsonpage129.
2OntheI/OSetupmenu,selectSensors→Speed→SpeedLog.
3ObservethattheSensorCongparameterdialogueappears
atthebottomofthemenueld.
307531/C
135