Section02ENGINE
Subsection 08 (BOTTOM END)
A35C4BA
Push oil seal no. 15 out.
A35C1GA
Carefully press the outer part of ceramic seal out.
NOTE: Use a mandrel with diameter of approxi-
mately 16 mm (0.63 in).
A35C4CA
1
1. 16 mm (.63 in) mandrel
A35C4DA
1
1. Outer part of ceramic seal
Remove sealant from bearing housing with sand
paper no. 180.
A35C4EA
1
1. Remove sealant
To extract bearing no. 17 either use a hammer
puller or an appropriate pusher.
Assembly
Reverse disassembly procedure and pay attention
to the following.
NOTE: Never put oil in the press fit area of the oil
seal and ceramic seal.
Push the new oil seal no. 15 in bearing housing
using the oil seal pusher (P/N 529 035 757).
mmr2005-118 67
To Next Page
Loading...
