313
You can also select and delete multiple events.
For details, see “Selecting multiple events”
(page 313).
To move an event
Delete an event, select an edit point, and press the
[
PASTE] button.
The deleted event is inserted after the selected event.
To insert before the selected event, press and hold the
[
SHIFT] button and press the [PASTE] button.
Copying an event
1
Select a copy source edit point.
2
Press the [COPY] button in the utility/shotbox
control block.
3
Select a copy destination edit point.
4
Press the [PASTE] button in the utility/shotbox
control block.
The copied event is inserted after the selected event.
To insert before the selected event, press and hold the
[SH
IFT] button and press the [PASTE] button.
You can also select and copy multiple events.
For details, see “Selecting multiple events”
(page 313).
Selecting multiple events
You can select multiple events as the edit target.
This operation is available when modifying, deleting, or
cop
ying an event.
To select all events
Press the [ALL] button, turning it on orange, in the utility/
sho
tbox control block.
To select multiple events within a specified
ra
nge
1
Select the first event for a specified range.
2
Press the [FROM TO] button in the utility/shotbox
control block.
“FROM XXX TO” (“XXX” is the current event
n
umber) is displayed on the display in the numeric
keypad control block.
3
Enter the number of the last event for the specified
range in the numeric keypad area in the numeric
keypad control block.
To change the number of the first event in the
sp
ecified range, press the [CLR] button. Enter the
number of the first event, press the [ENTER] button,
and then enter the number of the last event.
Enter a “.” (period) to specify a range from the first
even
t to the last event.
If the last event is not specified, the range up to the
l
ast event becomes the specified range.
4
Press the [ENTER] button.
The specified range is applied.
Merging registers
You can insert all events from another register at a
specified position.
1
Select an edit point.
2
Recall a register to merge.
Recall a macro register using one of the following
but
tons.
• Buttons with a set macro attachment (see page 326)
• Cross-point buttons in the cross-point control block
(see page 319)
• Buttons in cross-point pad in the cross-point control
block
/AUX bus control block (see page 319)
• Memory recall buttons in the Flexi Pad control
bl
ock (see page 318)
• Buttons in the numeric keypad area in the numeric
key
pad control block (see page 320)
3
Press the [PASTE] button in the utility/shotbox
control block.
All events in the recalled register are inserted after the
sel
ected event.
To insert before the selected event, press and hold the
[
SHIFT] button and press the [PASTE] button.
Undoing an edit operation
To undo an operation immediately after inserting,
modifying, or pasting an event, press the [UNDO] button
in the utility/shotbox control block.
Note
Note
Note
To Next Page
Loading...
Need help?
General
