Chapter 20 Switcher Setup (Switcher)
1216
Signal Input Settings (Input Menu)
2
Adjust the following parameter.
a) For down-conversion, the value is from –30 to +30 inclusive.
To return the edge crop image to the center
In the <Edge Crop Position> group, press [Center].
Setting the image position in letter box up-conversion mode
1
In the <Letter Box Position> group of the Switcher >Input >FC Adjust
menu, press [Position], turning it on.
2
Adjust the following parameter.
To return the letterbox image to the center
In the <Letter Box Position> group, press [Center].
Making enhancer settings
1
In the Switcher >Input >FC Adjust menu, press [Enhancer], turning it on.
2
Set the following parameters.
Parameter group [1/2]
Knob Parameter Adjustment Setting format Setting values
2 EC Position Image position
a)
1080 –120 to +120
720 –80 to +80
Knob Parameter Adjustment Setting format Setting values
2 LB Position Image position 1080i/59.94,
29.97PsF
–31 to +32
1080i/50,
25PsF
–36 to + 36
720P –30 to +30
Knob Parameter Adjustment Setting values
2 Detail Gain Adjust the edge
enhancement
sharpness
0 to 127
3 Limiter Adjust the
maximum signal
level to be added
to the original
signal
0 to 63
To Next Page
Loading...
