Chapter 20 Switcher Setup (Switcher)
1215
Signal Input Settings (Input Menu)
3
In the <Conversion> group, select one of the following.
Frame: Conversion in frame units
Field: Conversion in field units
Adaptive: Automatically switching between the above two modes
When Adaptive is selected, adjust the following parameter.
a) 1: Still priority mode, 2: Standard mode, 3: Motion priority mode
4
In the <Aspect> group, select one of the following.
Edge Crop: Add black bars on the left and right sides of a 4:3 aspect ratio
image to convert it to a 16:9 image.
Letter Box: Crop the top and bottom of a 4:3 aspect ratio image to convert
it to a 16:9 image.
Squeeze: Stretch a 4:3 image horizontally to covert it to a 16:9 image.
(For details of the image transformations, see the following figure.)
Setting the image position in edge crop up-conversion mode
1
In the <Edge Crop Position> group of the Switcher >Input >FC Adjust
menu, press [Position], turning it on.
Knob Parameter Adjustment Setting values
2 Motion Select Motion detection
sensitivity
1 to 3
a)
Original image (4:3) Up-converted image (16:9)
Edge Crop
Letter Box
Squeeze
To Next Page
Loading...
