Chapter 5 Wipes
312
Basic Procedure for Wipe Settings
Applying barrel or pincushion distortion to the edge of the wipe
pattern (Spring)
As the transition progresses, the edge of the pattern is subjected to barrel or
pincushion distortion.
A negative parameter value produces pincushion distortion, and a positive
value produces barrel distortion.
You can set the spring function independently for the main and sub patterns.
1
In the M/E-1 >Wipe menu, select HF5 ‘Main Modify.’
The Main Modify menu appears.
2
Press [Spring], turning it on.
3
Set the following parameters.
Applying a spiral effect to the wipe pattern (Spiral)
This deforms the pattern spirally.
Spring off
Spring on
Knob Parameter Adjustment Setting values
1 Gain Degree of barrel distortion –100.00 to +100.00
Spiral off
Spiral on
To Next Page
Loading...
