Chapter 10 Special Functions
498
Multi Program 2
Changing the key assignment for each output (Misc menu)
In Multi Program 2 mode you can change the key assignments independently.
The following describes an example using M/E-1, but the operation is the same
for other banks.
Notes
• This setting is linked to the setting in the Engineering Setup >Switcher >
Config >PGM Config menu.
• It is not possible to make this setting while the above PGM Config menu is
locked, or [Recall M/E Config] (see previous item) is set to Off.
1
In the M/E-1 menu, select first VF7 ‘Misc,’ then HF5 ‘Key Assign.’
The Key Assign menu appears, and the current key assignment is shown
in the status area.
2
Change the setting in “Key Enable” as required.
Keys recalled in a snapshot recall
If a snapshot is recalled independently on main or sub, this only retrieves the
settings for the key assigned to the recalled side. For example, if key 1 and key
2 are assigned on main, and key 3 and key 4 are assigned on sub, then if you
recall a snapshot on main, this only retrieves the settings for key 1 and key 2,
and the state of key 3 and key 4 assigned on sub is not affected.
Assigning sub preview output to preview selection buttons
You can assign the sub preview output to a preview selection button in the
fade-to-black control block or downstream key/fade-to-black control block.
For details, see “Overall Control Panel Settings (Config Menu)” in Chapter
19 (Volume 3).
When the Multi Program 2 license is valid, by assigning the “Shift” function to
a button, you can assign two preview outputs, “Shift” and “Unshift” to a single
button. To use the shift output, always assign “Shift” to some button.
Changing the matrix size to Standard
When using a router, if the matrix size is set to [Compact (128×128)], it is not
possible to control the utility 3 bus on the S-Bus. When using Multi Program
2, in the <Matrix Size> group of the Engineering Setup >Router/Tally >Router
menu, select [Standard (136×138)].
For details, see “Assigning Switcher Inputs and Outputs to S-Bus Space” in
Chapter 23 (Volume 3).
To Next Page
Loading...
