Chapter 14 Snapshots
894
Snapshot Operations in the Multifunction Flexi Pad Control Block
• When the reference region is M/E-x (x is a number) or P/P
• When the reference region is other than M/E-x or P/P, and effect
dissolve settings are possible
2
Add attributes with the following buttons.
[TEMP ATTR] button: Set a temporary attribute. Set this to Off to add
an attribute.
[EFF DISS] button: Add the effect dissolve attribute.
[DUR xxx] button: Set the effect dissolve duration.
The current setting is shown by “xxx.” When you press this button, the
memory recall section switches to numeric keypad input mode, and
you can enter the setting value.
[AUTO TRNS] button: Add the auto transition attribute.
[XHLD xxx] button: Add the bus cross-point hold attribute.
The affected bus is shown by “xxx.”
For details of attributes, see “Snapshot Attributes” (page 877).
To Next Page
Loading...
