Chapter 14 Snapshots
896
Snapshot Operations in the Multifunction Flexi Pad Control Block
4
To add a temporary attribute, press the [EDIT ENBL] button to switch to
editing mode, then press the [TEMP ATTR] button; you can now select the
temporary attribute with the following buttons.
[EFF DISS] button: Effect dissolve.
[DUR xxx] button: Effect dissolve duration. The current setting is shown
by “xxx.”
[AUTO TRNS] button: Auto transition.
[XHLD xxx] button: Bus cross-point hold. The affected bus is shown by
“xxx.”
For details of the operation mode of the [XPT HOLD] button, see
“Selecting the Bank to Make the Settings” in Chapter 20 (Volume 3).
For details of the temporary attribute and which attributes can be used,
see “Snapshot Attributes” (page 877).
Notes
Adding a temporary attribute does not affect the attribute settings saved in
registers.
To add a temporary attribute with the cross-point control block buttons,
press the following buttons, turning them on.
a) When setup setting is Xpt Hold mode
b) When setup setting is Key Disable mode
Notes
This setting is maintained until the next time the [XPT HOLD] button is
pressed.
5
Press the button in the memory recall section which shows the desired
register name.
The button you pressed lights yellow, and this recalls the snapshot.
The numeric display shows the selected register number after the bank
number.
To cancel a snapshot recall operation
After recalling a snapshot, to cancel the recall, press the [UNDO] button.
Temporary attribute to be
added
Button to press
A/B bus cross-point hold [XPT HOLD] button in background A/B bus
Key cross-point hold
Key bus [XPT HOLD] button
a)
Key disable
Key bus [XPT HOLD] button
b)
To Next Page
Loading...
