Chapter 16 Macros
945
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
4
Press the [MOD] button in the keyframe control block.
Modifying a particular range of events
1
Carry out steps 1 to 3 of the procedure in “Modifying a single event” (the
previous item).
2
Press the [FROM TO] button in the keyframe control block, turning it on.
The numeric display in the numeric keypad control block shows the
current event number and the indication “TO.”
3
To set the start of the range to other than the current event number, press
the [CLR/AUTO TRANS] button in the numeric keypad control block,
then enter the desired event number with the numeric keypad and press the
[ENTER] button. (This operation is not required when using the current
event number.)
4
Enter the event number for the end of the range and press the [ENTER]
button.
5
Press the [MOD] button in the keyframe control block.
This modifies the specified range of events simultaneously.
Modifying all events at the same time
1
Carry out steps 1 to 3 of the procedure in “Modifying a single event” (page
944).
2
Press the [ALL] button in the keyframe control block, turning it on.
3
Press the [MOD] button.
This modifies all events in the specified range simultaneously.
Deleting an event
1
Specify the edit point. (See page 943.)
2
To delete multiple events simultaneously, carry out either of the following
operations. (This operation is not required to delete the event at the edit
point only.)
To Next Page
Loading...
