Chapter 22 DCU Setup (DCU)
1235
Serial Port Settings (Serial Port Assign Menu)
6. Simple VDCP: disk recorder with low-performance communications (video disk
communications protocol)
7. Extended VTR (Abekas A53 protocol)
8. Mixer ESAM-II
9. AS ES-BUS: device supporting the AS ES bus protocol
Notes
Mixer ESAM-II cannot be operated from this system. It can only be
operated from an editing keyboard.
4
Press [Device Type Set].
The selected protocol is reflected on the left of the status area.
5
To enter the name of the serial port, press [Set] in the <Name> group.
A keyboard window appears. You can enter a name of not more than 16
characters.
If no name is set for the serial port, it is displayed as “DCUd_PORTs-p.”
d: 1 or 2 (DCU No.)
s: 2 to 6 (Slot No.)
p: 1 to 6 (Port No.)
6
Press [Enter].
To return the set name to the default name
Press [Clear] in the <Name> group.
7
From the <SCU Select> group, select the control panel (SCU1, SCU2 or
SCU3) assigned to operations on the external device connected to the
serial port.
Deleting the serial port assignment
1
In the DCU >Serial Port Assign menu, select the target for the setting
(DCU1 or DCU2) from the <DCU Select> group.
2
Using any of the following methods, specify the serial port.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
a) The range of setting values depends on the DCU port setting. (When the MKS-2700 is
connected, select 2 for the slot and a value in the range 1 to 6 for the port.)
Knob Parameter Adjustment Setting values
1 Port No Serial port
1 and upwards
a)
To Next Page
Loading...
