Appendix (Volume 3)
1297
Error Messages
Restore
Data
Restoring... Appears while restoring recovery data using
Menu 9999.
a)
Success!! Appears when recovery data has been
successfully restored using Menu 9999.
a)
Recovery binary on the USB
storage device is not found.
Recovery data for restoring using Menu 9999
cannot be found on the memory card. Check
that the recovery data has been correctly
copied to the memory card, and restart the
system to retry.
a)
Restore
Data
Failure.
Copying recovery data hasn’t
finished.
Restoring recovery data using Menu 9999
failed. Check that the recovery data has been
correctly copied to the memory card, and
restart the system to retry.
a)
Set Time/
Date
Error: Wrong Format. 7317: Engineering Setup >System
>Maintenance
In the above menu, an incorrect date and time
was specified. Specify the date and time
correctly.
Trim The Start TC or Stop TC is not
properly set.
2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if neither Start TC not Stop
TC is set.
2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if the interval between Start
TC (or Clip Begin) and Stop TC (or Clip End) is
the entire clip.
2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if the Start TC (or Clip Begin)
value is greater than the Stop TC (or Clip End)
value.
This file is locked. 2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if the file is locked.
This file is using for playback. 2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if the file is being played
back.
Warning No Switcher information
available.
Please confirm “Network
Configuration” on Page 7311.
When starting up the menu system, the
switcher is not present in the system
information. Check the Data LAN connections,
and in Menu 7311: Engineering Setup >System
>Network Config, retry [Auto Config].
Icon Title Message Description
To Next Page
Loading...
