Chapter 3 Signal Selection and Transitions
154
Signal Selection
When the [2ND] button is unlit
The cross-point buttons and reentry buttons in the auxiliary bus control block
have separate upper (1st row) and lower (2nd row) numbers.
In the case of a 32-button layout, the button numbers are as follows.
When the [2ND] button is lit
Different buses can be assigned to the 1st-row buttons and 2nd-row buttons.
When the 32nd button is set as a shift button, the 1st-row buttons and 2nd-row
buttons both have the following button numbers.
Auxiliary bus control block button numbers ([2ND] button lit)
Inhibiting cross-point button operations
For each cross-point button, you can temporarily inhibit operations.
Notes
This setting is cleared when you reset the control panel.
Assigning a button to the function of disabling cross-point button
operation
You can assign the button to be used for the operation to the [PRE MCRO]
button, in setup. (See “Overall Control Panel Settings (Config Menu)” in
Chapter 19 (Volume 3).)
You can also use the [Inhibit Set] and [Inhibit All Clear] functions, assigned to
user preference buttons. (See “Setting Button Assignments (Prefs/Utility
Menu)” in Chapter 19 (Volume 3).)
Buses for which operations can be inhibited
This setting applies to the auxiliary bus control block (when using the CCP-
8000) and the cross-point buttons in each switcher bank. However, when using
Auxiliary bus control block button numbers ([2ND] button unlit)
Button Button Button numbers
1st row From the left end to the 31st button 1 to 31
Reentry buttons 121 to 124
2nd row From the left end to the 31st button 32 to 62
Reentry buttons 125 to 128
Button Number when the shift
button is not pressed
Number when the shift
button is pressed
From the left end to the
31st button
1 to 31 32 to 62
Reentry buttons 121 to 124 125 to 128
To Next Page
Loading...
