Chapter 3 Signal Selection and Transitions
164
Key Priority Setting
Transition control block (standard type)
Changing the currently inserted key priority
1
If the next transition selection button [KEY PRIOR] is on, press another
next transition selection button to turn the [KEY PRIOR] button off.
(When the [KEY PRIOR] button is on, the transition control block
switches to the mode for changing the key priority for after the transition.)
2
Holding down the [PRIOR SET] button, press the one of the next transition
selection buttons [KEY1] to [KEY4] ([DSK1] to [DSK4] buttons in the
PGM/PST bank) for the key to appear on top.
Notes
• To select [Key5] to [Key8], or [DSK5] to [DSK8] requires an
assignment. For details, see “Assigning Buttons for Selection of Keys 5
to 8 in the Setup Menu” (page 544).
• The key priority establishes a separate priority order within each of the
groups of keys 1 to 4 and keys 5 to 8. You can make any setting within
the groups of keys 1 to 4 or keys 5 to 8, but not for combinations of keys
from different groups. For example, it is not possible to set a priority
sequence of keys 1, 5, and 2. For details, see “Setting the Key Priority
in the Transition Control Block” (page 163).
The selected key now appears on top, on the program monitor.
The priority of keys other than the selected one does not change.
Next transition
selection buttons
KEY PRIOR button
PRIOR SET button
To Next Page
Loading...
