Chapter 3 Signal Selection and Transitions
180
Executing a Transition
4
Press the [TRANS] button.
You can now set the M/E-1 block background transition rate.
5
Watching the alphanumeric display, enter the transition rate you want to
set with the memory recall section button.
If required, press the [TC] button to switch the input mode (frame count
input or timecode input).
• Enter a value of up to three digits.
• To cancel the input, press any of the mode selection buttons.
6
Press the [ENTR] button.
Setting the transition rate by a menu operation
1
In the switcher bank, select first VF7 ‘Misc,’ then HF1 ‘Transition.’
The Transition menu appears.
2
Select any transition type in the <Transition Type> group.
3
Turn the knob to set the transition rate.
Displaying the transition rates in a menu and changing the
settings
For each of the M/E and PGM/PST banks, you can display the transition rate,
independent key transition rate and fade-to-black transition rate, and change
the settings.
Knob Parameter Adjustment Setting values
1 Transition Rate Transition Rate 0 to 999 (frame count)
To Next Page
Loading...
