Chapter 4 Keys
231
Key Setting Operations Using Menus
• Turn the knob.
5
In the <Assign> group, select the video signal or key signal from the V/K
pair to assign to the key source.
6
Press [Set Xpt].
This selects the key source signal.
Selecting key fill
For example, to select the key fill for M/E-1 key 1, use the following
procedure.
1
In the M/E-1 >Key1 >Type menu status area, press “Fill.”
The Signal Select menu appears.
2
In the <Target> group, press [Fill].
3
Select the fill signal from the list on the right.
4
Press [Set Xpt].
This selects the key fill signal.
Carrying out a color mix for key fill
When [Matte] is selected for key fill, you can combine color 1 and color 2. For
the combination, you can use not only a key wipe generator pattern, but also
the dedicated pattern for key edge color mix.
1
In the <Key Fill> group of the Type menu, select [Matte] and press [Matte
Adjust].
The Matte Adjust menu appears.
2
Select [Mix Color] in the <Fill Matte> group.
3
Adjust the following parameters.
Knob Parameter Setting Values
1 No Button number 1 to 128
Knob Parameter Adjustment Setting values
1 Size Pattern size 0.00 to 100.00
2 Soft Softness of the edge of the
pattern
0.00 to 100.00
To Next Page
Loading...
