Sony MVS -8000X - Page 236

Chapter 4 Keys
236
Key Setting Operations Using Menus
Notes
In the emboss function it is not possible to set [Fine Key] on.
• When the edge type is normal, drop border or shadow, enabling the [Fine
Key] function keeps [Key Drop] on.
• When applying a border to the key edge, enabling the [Fine Key]
function halves the border width setting range.
To fix key fill and key source in key drop off mode
1 In the Edge menu, press [Key Delay Mode].
The Key Delay Mode menu appears.
2 Press [Frame Delay], setting it to On.
Notes
This function uses the resizer, and therefore the expected result of the
setting may not be obtained if conditions do not allow the resizer to be
used.
Carrying out a color mix for the key edge fill matte
When you select ‘Matte’ for the edge fill of a border, drop border, or shadow,
you can create a combination of color 1 and color 2 using a wipe pattern
generated by the dedicated pattern generator.
1 In the <Edge Fill> group of the Edge menu, select [Matte], then press
[Matte Adjust].
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 Top Key top edge position –2.00 to +2.00
2 Left Key left edge position –2.00 to +2.00
3 Right Key right edge position –2.00 to +2.00
4 Bottom Key bottom edge position –2.00 to +2.00
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 H Phase Key horizontal position Left edge position
value shown
2 V Phase Key vertical position Top edge position
value shown