Sony MVS -8000X - Page 255

Chapter 4 Keys
255
Key Setting Operations With the Key Control Block
• “Key drop ON” mode
a) In the “4H mode” and when [Fine Key] (page 235) is on, the setting value range is 0 to 4.
To adjust the edge fill color
When [DROP BDR] or [SHDW] is selected, the [MORE] button lights amber.
Pressing the [MORE] button to turn it green then allows you to adjust the edge
fill color parameters with the knobs.
Setting the outline parameters
When the [OUTLINE] button is lit green, the parameter settings depend on the
key type and whether the separate edge function is active. To activate the
separate edge function, press [Separate Edge], setting it on, in the Edge menu
for the key.
• Separate edge off
a) In the “4H mode” and when [Fine Key] (page 235) is on, the setting value range is 0 to 4.
b) When a wipe pattern key or key wipe pattern key is selected as the key type
• Separate edge on
The outline width settings can be made independently for left, right, top, and
bottom sides. The separate edge function is only available when luminance
key, linear key, or chroma key is selected as the key type.
Knob Parameter Adjustment Setting values
1Width Width
0 to 8
a)
2 Position Position 359 to 0
4 Density Density 0 to 100
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0 to 100
2 Saturation Saturation 0 to 100
3 Hue Hue 359 to 0
4 Density Density 0 to 100
Knob Parameter Adjustment Setting values
1 Width Outline width
0 to 8
a)
(0 to 100)
b)
4 Density Outline density 0 to 100
Knob Parameter Adjustment Setting values
1 Top Top edge width
0 to 8
a)
2 Left Left edge width
0 to 8
a)