Chapter 5 Wipes
313
Basic Procedure for Wipe Settings
Making a wipe pattern like a Venetian blind (Pairing)
This slits the pattern into multiple strips, making it like a venetian blind.
H: Create slits in the horizontal direction.
V: Create slits in the vertical direction.
• The parameter Width determines the width of the slits.
• The parameter H Offset determines the spacing in the horizontal direction.
If a negative value is set, the even-numbered pairs of strip and slit move to
the left, and the odd-numbered pairs move to the right. (The value –100.00
represents the maximum movement.)
If a positive value is set, the even-numbered pairs of strip and slit move to
the right, and the odd-numbered pairs move to the left. (The value +100.00
represents the maximum movement.)
• The parameter V Offset determines the spacing in the vertical direction.
If a negative value is set, the even-numbered pairs of strip and slit move
upward, and the odd-numbered pairs move downward. (The value –100.00
represents the maximum movement.)
If a positive value is set, the even-numbered pairs of strip and slit move
downward, and the odd-numbered pairs move upward. (The value +100.00
represents the maximum movement.)
1
In the M/E-1 >Wipe menu, select HF5 ‘Main Modify.’
The Main Modify menu appears.
2
In the <Pairing> group, select the slit direction.
H: Create slits in the horizontal direction.
V: Create slits in the vertical direction.
3
Set the following parameters.
Pairing off
Pairing on
Knob Parameter Adjustment Setting values
1 Width Width of the slits 1 to 128 (integer)
2 H Offset Spacing in the horizontal direction –100.00 to +100.00
3 V Offset Spacing in the vertical direction –100.00 to +100.00
To Next Page
Loading...
