Chapter 5 Wipes
315
Basic Procedure for Wipe Settings
Fringe
This modulates the pattern, applying waviness in the radial direction to edges.
The parameter Speed determines the speed of waves.
A value of –100.00 generates the maximum counterclockwise speed of waves,
and a value of +100.00 the maximum clockwise speed.
You can apply modulation independently to the main pattern and sub pattern.
1
In the M/E-1 >Wipe menu, select HF5 ‘Main Modify.’
The Main Modify menu appears.
2
Depending on the desired effect, in the <Modulation> group select one of
the following.
H (Horizontal modulation): Modulate the pattern, applying waviness in
the horizontal direction to edges.
V (Vertical modulation): Modulate the pattern, applying waviness in the
vertical direction to edges.
Fringe (Radial modulation): Modulate the pattern, applying waviness in
the radial direction to edges.
3
Set the following parameters.
.
Knob Parameter Adjustment Setting values
1 Amplitude Amplitude of modulation 0.00 to 100.00
2 Frequency Frequency of modulation 0.00 to 100.00
3 Speed Speed of waves –100.00 to +100.00
4 Shape Form of the modulation 1 to 3
To Next Page
Loading...
