Chapter 5 Wipes
328
Wipe Snapshots
Button displays
In setup you can select whether the memory recall buttons show the pattern
number or register name.
See “Operation Settings (Operation Menu)” in Chapter 19 (Volume 3).
Saving a wipe snapshot from the menu
1
Set up the wipe you want to save.
2
In the Wipe Snapshot menu, press [Store], lighting it amber.
3
Press the memory recall button for the register in which you want to save.
Notes
• If you press a button which is already lit, this overwrites the contents of the
register.
• When both the main pattern and sub pattern are selected for a pattern mix,
the button in the memory recall section shows only the main pattern.
Recalling a wipe snapshot from the menu
In the Wipe Snapshot menu, press the memory recall button for the wipe
snapshot you want to recall.
This recalls the wipe snapshot, and the button you pressed lights amber.
In the upper left is shown the currently recalled register name or number.
Memory recall buttons
To Next Page
Loading...
