Chapter 6 DME Wipes
350
Basic Procedure for DME Wipe Settings
• Flip Tumble: flip tumble
• Mirror/Sphere: mirror and sphere
• Character Trail: character trail
• Wave/Ripple: wave and ripple
• Page Turn/Roll: page turn and page roll
• Frame I/O/P in P: frame in/out and picture-in-picture
• 2D Trans/3D Trans: 2D trans and 3D trans
• Sparkle/Split Slide: sparkle and split slide
• Mosaic/Defocus: mosaic and defocus
• Brick: brick
• User Program: user programmable DME
Selectable DME wipe pattern groups in one-channel mode: All of the
above groups except for Brick.
Selectable DME wipe pattern groups in two-channel mode: Slide/
Squeeze, Page Turn/Roll, Frame I/O, PinP, 3D Trans, Brick and User
Program.
Selectable DME wipe pattern groups in three-channel mode: User
Program and Brick.
For details of DME wipe patterns, see “Types of DME Wipe Pattern”
(page 338) and “DME Wipe Pattern List” (page 502).
The patterns from the selected pattern group appear on the screen.
3
Press the button to select the desired pattern.
Notes
For a key transition, the page turn, page roll and picture-in-picture cannot
be used.
Adjusting DME wipe pattern parameters
Of the DME wipe patterns, the following have parameters that can be adjusted.
When Brick (for two channels) is selected (pattern numbers 2801
to 2804, 2811 to 2814)
Knob Parameter Adjustment Setting values
1 Side V Size X Horizontal magnification 0.01 to 8.00
2 Side V Size Y Vertical magnification 0.01 to 8.00
3 Height Height of brick 0.01 to 100.00
4 Center X Horizontal center position
–100.00 to +100.00
a)
5 Center Y Vertical center position
–100.00 to +100.00
b)
To Next Page
Loading...
