Sony MVS -8000X - Page 375

Chapter 6 DME Wipes
375
DME Wipe Pattern Operations in the Multifunction Flexi Pad Control Block
You can adjust the parameters selected with these buttons using the control
knobs, when the button is lit green.
• When border is selected
• When soft border is selected
Buttons for positioning the DME wipe pattern
POS (position): Adjusts the position of the DME wipe pattern.
CNTR (center): Returns the DME wipe pattern position to the center.
When you press the [POS] button, the alphanumeric display first shows the
name of the parameter, “H” or “V,” and then the value of the parameter.
When the [POS] button is lit green, you can adjust the position of the pattern
with the control knobs.
Knob Parameter Adjustment Setting values
1 W Border width 0 to 100
2 L Luminance 0 to 100
3 S Saturation 0 to 100
4H Hue 0 to 359
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 W Border width 0 to 100
2 I Degree of softening of
inside of border
0 to 100
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 L Luminance 0 to 100
2 S Saturation 0 to 100
3H Hue 0 to 359
Knob Parameter Adjustment Setting values
1 H Horizontal position –200 to +200
2 V Vertical position –200 to +200
3 H (R) Relative horizontal
movement
–400 to +400
4 V (R) Relative vertical movement –400 to +400