Appendix (Volume 1)
546
Using Keys 5 to 8
First in the Setup menu, assign the following to any buttons:
[KEY1/5], [KEY2/6], [KEY3/7], [KEY4/8], [SHIFT], and [ADD]
By way of example, this is the procedure for [KEY1/5].
To select key 5
Press [SHIFT], turning it on, then press the [KEY1/5] button.
To select keys 1 and 5 simultaneously
1
Press the [KEY1/5] button alone.
This selects key 1.
2
Press [SHIFT], turning it on.
3
Holding down [ADD], press the [KEY1/5] button.
This selects keys 1 and 5 simultaneously.
Selecting Input Signals for Keys 5 to 8 in the Cross-
Point Control Block
Buttons used for selection of keys 5 to 8
For the positions of the following buttons in the cross-point control block, see
page 55.
a) Button previously assigned in the Setup menu to selection of keys 5 to 8
To select the key 5 fill signal
1
Turn on the dedicated SHIFT button.
2
Turn off the [KEY3] button.
Key Key row Dedicated SHIFT
button
a)
[KEY3]/[KEY4] button
5 Key 1 row Lit [KEY3] button off
6 Key 2 row [KEY4] button off
7 Key 1 row [KEY3] button lit
8 Key 2 row [KEY4] button lit
To Next Page
Loading...
