Sony MVS -8000X - Page 594

Chapter 11 DME Operations
594
DME Special Effect Operations
• 16:9 mode
Setting the border color
The operation differs depending on the DME used (MVE-8000A or MVE-
9000).
When the MVE-8000A is used
Press [Border Color], turning it on, and set the following parameters.
When the MVE-9000 is used
Use the buttons in the <Border Fill> group to select the signal to insert in the
border.
Flat Color: single color
Mix Color: mix color signal set in the Color Mix menu (see page 619)
Ext Video: an external video signal input to the Ext IN connector
If Flat Color is selected, adjust the following parameters.
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 H Border width on left and right
sides
Left value shown
2 V Border width on top and bottom
sides
Top value shown
3 All Border width on all sides Left value shown
5 Density Border density 0.00 to 100.00
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Top Border width on top side –4.50 to +4.50 (SD)
–18.00 to +18.00 (HD)
2 Left Border width on left side –8.00 to +8.00 (SD)
–32.00 to +32.00 (HD)
3 Right Border width on right side –8.00 to +8.00 (SD)
–32.00 to +32.00 (HD)
4 Bottom Border width on bottom side –4.50 to +4.50 (SD)
–18.00 to +18.00 (HD)
5 Density Border density 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00