Chapter 11 DME Operations
654
DME Special Effect Operations
To apply the Split effect
With the Split menu displayed, use the following procedure.
1
In the <Mode> group, select the split method.
Single: Leave gaps between splits.
Double: Fill gaps between splits with the same image.
2
Set the following parameters.
To set the split position
1
Press [Position].
2
Set the following parameters.
a) Setting for SD 4:3, SD 16:9
b) Setting for HD 4:3, HD 16:9
Split Slide settings
You can set the degree of transition, the degree of randomness in the distance
moved by each block, the degree of sliding, block width, block angle, and other
parameters.
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 Transition H Degree of left and right separation –100.00 to +100.000
2 Transition V Degree of top and bottom
separation
–100.00 to +100.000
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Top Amount of movement of top –100.00 to +100.000
2 Left Amount of movement of left –100.00 to +100.000
3 Right Amount of movement of right –100.00 to +100.000
4 Bottom Amount of movement of bottom –100.00 to +100.000
Knob Parameter Adjustment Setting values
1 H Degree of left and right
separation
–4.000 to +4.000
a)
–16.000 to +16.000
b)
2 V Degree of top and bottom
separation
–3.000 to +3.000
a)
–12.000 to +12.000
b)
To Next Page
Loading...
