Chapter 11 DME Operations
682
DME Special Effect Operations
a) At the setting 0.00, there is no afterimage. At a setting of 100.00, the afterimage does not
decay.
4
In the <Decay Mix Mode> group, select the way in which the video signal
is blurred.
Soft: mix the live image and the afterimage.
Hard: show the lighter of the live image and afterimage.
5
To erase the afterimage, press [Decay Eraser], turning it on.
Erasing the afterimages that remain in memory whenever a
keyframe is passed
Press [Decay Eraser], turning it on.
When the effect passes a keyframe, the afterimage is erased before writing a
new afterimage.
Selecting the freeze timing
In the <Decay Freeze Timing> group, select the timing for motion decay
freezing.
Frame: freeze in frame units.
Field: freeze in field units.
Notes
The freeze timing setting is not required when the following signal formats are
being used.
Signal formats: 1080P/50, 1080P/59.94, 1080PsF/23.976, 1080PsF/24,
1080PsF/25, 1080PsF/29.97, 720P/50, 720P/59.94
Applying stardust to the afterimage portion
The afterimage portion becomes stardust, and gradually disappears.
1
Press the [DUST] button, turning it on.
2
Set the following parameters.
Knob Parameter Adjustment Setting values
1 Video Decay Degree of blurring of the video
signal
0.00 to 100.00
a)
Knob Parameter Adjustment Setting values
1 Decay Dust Amount of the afterimage
disappearing as stardust
a)
0.00 to 100.00
To Next Page
Loading...
