Chapter 11 DME Operations
703
DME Special Effect Operations
Notes
There is no Radius setting when Line is selected in the <Spot Mode>
group.
To rotate the ring
1
Press [Ring Speed], turning it on.
The display on knob 3 that was visible when [Ring] was selected changes.
2
Set the following parameter.
a) –100.00 is four rotations per second in the counterclockwise direction, and +100.00 is four
rotations per second in the clockwise direction. 0.00 stops the rotation.
To invert the lighted area
Press [Light Invert], turning it on.
The lighted area is inverted.
To add color to the light source
1
In the Light 1 menu, press [Light Color Adjust].
The Light Color Adjust menu appears.
2
In the <Fill Blending Mode> group, select how the light and image should
be blended.
Mix: Light as if reflected from a mirror.
Multiply: Light as if reflected from a dull surface (diffuse reflection).
3
If you selected Mix, select the fill color in the <Fill Source> group.
Flat Color: A monochrome matte.
Hue Rotation: Color matte with a color that gradually varies.
4
According to the selection, set the following parameters.
• When you selected Flat Color
Knob Parameter Adjustment Setting values
3 Speed Rotation speed and direction
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
To Next Page
Loading...
