Sony MVS -8000X - Page 71

Chapter 2 Menus and Control Panel
71
Names and Functions of Parts of the Control Panel
control block. Each button functions as
follows.
(From upper left to right in the above
figure)
[M/E1] to [M/E3]: DEV1 (device 1) to
DEV3 (device 3)
[P/P]: DEV4 (device 4)
[USER]: FM1CLIP (frame memory
clip 1)
[Unused]: FM2CLIP (frame memory
clip 2)
[DME1] to [DME4]: DEV5 (device 5)
to DEV8 (device 8)
[Unused]: FM LOOP (frame memory
loop)
[DME5] to [DME8]: DEV9 (device 9)
to DEV12 (device 12)
To exit from this mode, press the
[DEV] button again, turning it off.
When the [RUN CTRL] button is
selected: This enables the effect run
control mode in the device control
block.
When the [RSZR CTRL] button is
selected: This enables the resizer
control mode in the device control
block.
In resizer control mode, select the key with
the region selection button [K1RSZ] to
[K8RSZ].
The functions of the operation buttons,
trackball, and Z-ring vary with the
operation mode as follows.
[FX CTRL] button: Leave this button off
for operation.
Alternatively, for details of operation
of this button, refer to the help
information for the MPES-FX01
Programmable Effector software.
b Operation buttons
When the positioner operation mode is
enabled
K1 CB1: Press this button to enable wipe
pattern position setting for key 1
(DSK1).
When the [USER] button is selected,
pattern position setting for color
background 1 is enabled.
K2 CB2: Press this button to enable wipe
pattern position setting for key 2
(DSK2).
When the [USER] button is selected,
pattern position setting for color
background 2 is enabled.
K3: Press this button to enable wipe pattern
position setting for key 3 (DSK3).
K4: Press this button to enable wipe pattern
position setting for key 4 (DSK4).
MAIN: Press this button to enable main
wipe pattern position setting for normal
transitions.
SUB: Press this button to enable sub wipe
pattern position setting for normal
transitions.
Among the [K1 CB1] button, [K2 CB2]
button, [K3] button, [K4] button, [MAIN]
button, and [SUB] button, you can select
multiple buttons.
By setting the operation mode in setup, you
can select keys 5 to 8 with the [K1 CB1],
[K2 CB2], [K3], and [K4] buttons. In this
case, it is not possible to select more than
one of keys 1 to 8.
For details of assignment of keys 5 to 8, see
“Assigning Buttons for Selection of Keys 5
to 8 in the Setup Menu” (page 544) in
Appendix (Volume 1).
POS: Press this button to enable pattern
movement in the x-axis and y-axis
directions with the trackball.
When the [USER] button is selected,
this enables the trackball to move the
pattern in the x-axis and y-axis
directions, and the Z-ring to adjust the
size of the pattern.