Chapter 11 DME Operations
710
DME Special Effect Operations
6
In the <Interpolation Mode> group, set the number of pixels to use in
interpolation.
Multi: Use multi-point interpolation. This gives higher picture quality.
Linear: Use two-point interpolation.
7
In the <Filter Mode> group, select the method used to show the picture
reduced or expanded.
Mode1 (standard): Even when the picture is reduced, add compensation
so that it can be seen clearly.
Mode2 (soft): Suppress aliasing when expanding or reducing the picture.
Mode3 (sharp): Do not suppress aliasing when expanding or reducing the
picture.
Applying the anti-moire filter
You can reduce the moire patterns created by interpolation when an image is
enlarged, compressed, or rotated.
Notes
This function is effective only when the HD signal format is used on the MVE-
8000A.
1
In the DME menu, select VF6 ‘Input/Output’ and HF3 ‘Process.’
The Process menu appears.
2
Press [Anti Moire Filter], turning it on.
3
Set the following parameter.
Knob Parameter Adjustment Setting values
1 Mode Degree of motion detection 1 to 4
Knob Parameter Adjustment Setting values
1 Anti Moire
Filter
Amount of moire reduction 1 to 8
To Next Page
Loading...
