Chapter 12 External Devices
747
Control of VTRs, Extended VTRs, and Disk Recorders
Notes
• In an effect register set on the VTR/disk recorder timeline, Cueup & Play
settings are not possible. To add Cueup & Play settings to such a register,
first clear the VTR/disk recorder timeline setting before carrying out the
operation.
• When using a disk recorder with Cueup & Play, if you carry out the
following sequence of operations, the system may freeze on the frame of the
start point.
1. Press the [RUN] button to play to a point close to the end of a file.
2. Stop playback.
3. Press the [RUN] button once more.
In such cases, first recall a different register, then carry out the following
sequence:
1. Recall the original register again.
2. Press the [REWIND] button.
3. Press the [RUN] button.
Making and saving settings relating to Cueup & Play
1
Press the [EFF] button in the numeric keypad control block, turning it on.
This assigns the numeric keypad control block to keyframe operations, and
the [RCALL] button lights.
2
Press the region selection button for the region for which you want to make
the setting, turning it on.
You can select more than one button.
3
Enter the number of the register to be recalled with the numeric keypad
buttons.
To search for an empty register, instead of entering a number, press the [.]
(period) button.
The display shows the register number. A letter “e” or “E” after the number
indicates the register status, as follows:
e: This register is empty in the selected region.
E: This register is empty in all selectable regions.
4
Press the [ENTER] button.
This recalls the register you selected in step 3.
5
When using the device control block (trackball) or device control block
(joystick), press the [DEV] button in the device control block, turning it
on.
To Next Page
Loading...
