Sony MVS -8000X - Page 855

Chapter 14 Snapshots
855
Snapshot Operations From the Numeric Keypad Control Block
a) When Xpt Hold mode is selected in setup.
b) When Key Disable mode is selected in setup.
For the setup setting, see “Settings Relating to Keys, Wipes, Frame
Memory and Color Correction (Key/Wipe/FM/CCR Menu)” in Chapter 20
(Volume 3).
For details of temporary attributes and available attributes, see “Snapshot
Attributes” (page 849).
Notes
• The cross-point hold and key disable settings are maintained until you
next press the [XPT HOLD] button.
• Applying temporary attributes does not affect the contents of the
register.
• It is not possible to apply temporary attributes to a master snapshot.
5 Press the [ENTER] button.
This recalls the specified snapshot, and the reference region name and
recalled register number appear in the display.
If you applied the effect dissolve or auto transition temporary attributes in
step 4, the corresponding buttons go off.
When a master snapshot is recalled, the region selection buttons light
according to the saved region information.
To cancel a snapshot recall operation
After saving a snapshot, to cancel the recall, press the [UNDO] button.
Notes
It is not possible to cancel recalling a master snapshot.
Creating and saving a master snapshot with the numeric keypad
control block
To create and save a master snapshot with the numeric keypad control block,
refer to the operations in “Creating and Saving a Master Timeline Using the
Buttons in the Numeric Keypad Control Block” (page 830). Note, however,
that in place of the [EFF] button in the numeric keypad control block, the
[SNAPSHOT] button is used.
Numeric keypad
control block
Effect dissolve [+/–/EFF DISS] button
Auto transition [CLR/AUTO TRANS] button
Control block Temporary
attribute to apply
Button