Chapter 15 Utility/Shotbox
890
Shotbox Register Creation
Creating a shotbox register
1
In the Shotbox menu, press VF1 ‘Register’ and HF1 ‘Store/Recall.’
The Store/Recall menu appears.
In the status area, the settings for each register appear as follows.
Region settings: Appear as “Sxxx” when a snapshot is allocated, and as
“Exxx” when an effect is allocated. (xxx is the register number.) The
register name also appears. If nothing is allocated, nothing appears in
the display.
Register lock setting: When the register is write-protected, an “L” (for
“lock”) appears.
Empty status: When the register is empty, an “E” (for “empty”) appears.
Auto run setting: When this is enabled, so that an effect is executed
simultaneously with recall, “AR” appears.
Shotbox register name: This shows the shotbox register name.
2
If necessary, switch the region display by pressing one of the following
buttons in the status area.
M/E, P/P: Shows the allocations for M/E-1 (“M/E1”), M/E-2 (“M/E2”),
M/E-3 (“M/E3”), M/E-4 (“M/E4”), and P/P (“P/P”).
User: Shows the allocations for User1 (“USR1”) to User8 (“USR8”).
DME: Shows the allocations for DME ch1 (“DME1”), ch2 (“DME2”),
ch3 (“DME3”), ch4 (“DME4”), ch5 (“DME5”), ch6 (“DME6”),
ch7 (“DME7”), and ch8 (“DME8”).
DEV1-8: Shows the allocations for Device1 (“DEV1”) to Device8
(“DEV8”).
DEV9-12: Shows the allocations for Device9 (“DEV9”) to Device12
(“DEV12”).
Misc: Shows the allocations for P-Bus (“PBUS”), GPI (“GPI”), Router
(“RTR”), and Macro (“MCRO”).
3
Using any of the following methods, select the register you want to create
(or edit).
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
4
Press [Edit].
The Edit menu appears, and it is now possible to make the settings for the
specified register.
Knob Parameter Adjustment Setting values
1 Shotbox Reg Shotbox register number 1 to 99
To Next Page
Loading...
