Chapter 16 Macros
917
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
4
Move to the edit point which is the destination within the macro to which
you want to copy the events.
5
To paste the contents of the paste buffer after the edit point, press the
[PASTE] button in the keyframe control block.
To paste before the edit point, hold down the [SHIFT] button in the
keyframe control block and press the [PASTE] button.
This copies the events from the paste buffer.
Inserting a pause event
1
Press the [PAUSE] button in the keyframe control block, lighting it green.
The indication “PAUSE” appears in the numeric keypad control block
display.
2
If required, press the [AUTO INS] button in the keyframe control block to
toggle the auto insert mode on or off.
3
Enter the pause duration with the numeric keypad control block (0 or 1 to
999 (frames)).
4
Press the [ENTER] button.
• If auto insert mode is on, this sets the pause duration, and inserts the
pause event.
• When auto insert mode is off, continue to step 5.
5
When auto insert mode is off, press the [INS] button in the keyframe
control block to insert the pause event.
Merging macro register data
1
Specify the edit point. (See page 913.)
2
Press the [RCALL] button in the numeric keypad control block, lighting it
amber.
3
Enter the number of the macro register you want to copy using the numeric
keypad buttons.
The display shows the register number.
4
Press the [ENTER] button.
To Next Page
Loading...
