Chapter 16 Macros
926
Macro Operations in the Standard Type Flexi Pad Control Block
• During macro editing, if you press a button for which a macro attachment is
set, the macro within the register assigned to the button is merged into the
macro being edited. However, the macro assigned to the button is not
executed.
• While carrying out macro editing in the Flexi Pad control block, absolutely
no macro operations are possible in the Flexi Pad control blocks for other M/
E and PGM/PST banks. Macro operations from the numeric keypad control
block or Multifunction Flexi Pad control block are also not possible.
To cancel the saving of a macro
To cancel the saving of a macro immediately after performing it, hold down the
[STORE STATS] button and press the [UNDO] button.
Inserting a pause event
1
Press the [PAUS] button in the memory recall section.
The buttons in the memory recall section change as follows.
2
Enter the length of pause you want to set (0 to 999 frames).
3
Press the [PAUS ENTR] button.
This sets the pause length, and inserts the pause event.
The memory recall section display returns to its former state.
Deleting a macro
1
In the Flexi Pad control block, press the [MCRO] button.
This assigns the Flexi Pad control block to macro operations.
The numeric display shows the previously selected bank number and the
number of the last recalled register.
To Next Page
Loading...
