Chapter 16 Macros
954
Macro Attachment Assigning
The cross-point button you pressed flashes amber, and the register you
recalled in step 1 is assigned to the button.
If you make both pre macro and post macro settings for the same
button
The later setting is valid.
To set a macro attachment without changing cross-points
When you set a macro attachment to a cross-point button, you can make the
setting without changing the bus cross-points. Carry out this selection in the
Engineering Setup >Panel >Operation menu. For details, see “Setting the
Macro Execution Mode” in Chapter 19 (Volume 3).
To make a macro attachment setting in macro only mode
Notes
To carry out this operation, it is first necessary to assign the “Macro Only Set”
function to the user preference buttons in the menu control block or the utility/
shotbox control operation. Carry out this assignment in the Eng Setup >Panel
>Prefs/Utility menu. (For details, see “Setting Button Assignments (Prefs/
Utility Menu)” in Chapter 19 (Volume 3).)
To make a macro attachment in macro only mode, use the following procedure.
PRE MCRO button
POST MCRO button
Background A row
Background B row MCRO ATTCH ENBL button
To Next Page
Loading...
