Sony MVS -8000X - Page 956

Chapter 16 Macros
956
Macro Attachment Assigning
3 Hold down the [PRE MCRO] or [POST MCRO] button
1)
in the cross-
point control block, and press the [LIMIT SET] or [PRIOR SET] button in
the control block containing the fader lever operated in step 2.
1) Only when setting a macro attachment to the start point or end point of fader lever
operation, use [PRE MCRO] and [POST MCRO] in distinction, as follows.
To set the operation start point (0%): hold down [PRE MCRO] for the operation.
To set the operation end point (100%): hold down [POST MCRO] for the operation.
This assigns the register recalled in step 1 to the fader lever position
selected in step 2.
To check a macro attachment setting
Hold down the [PRE MCRO] or [POST MCRO] button in the cross-point
control block. While it is held down, the fader lever position where the macro
attachment is set appears in the following places.
• Transition indicator in the transition execution section: The indicator
lights at the position where the macro attachment is set.
• Transition rate indication in the transition execution section: This shows
the fader lever position where the macro attachment is set, as a percentage
value. (Fader lever start position as 0%, end position 100%)
Removing macro attachment settings
To cancel a macro attachment to a button
Hold down the [PRE MCRO] button or [POST MCRO] button, and press a
button that is flashing in the background A row. The button for which the
macro attachment is set stops flashing and goes off, and this removes the
setting.
To cancel a macro attachment to a fader lever
Hold down the [PRE MCRO] or [POST MCRO] button in the cross-point
control block, and press the [LIMIT SET] or [PRIOR SET] button in the
control block containing the fader lever having the macro attachment set.
To remove all macro attachment settings in a single operation
You can remove all macro attachment settings in a single operation.
1 In the Macro menu, select VF2 ‘Attachment.’
2 Press [All Clear].
A confirmation message appears.
3 Select [Yes].
This deletes all macro attachment setting data.