Chapter 2 Menus and Control Panel
96
Names and Functions of Parts of the Control Panel
100% to zero in the second half while
the new video is maintained at 100%.
WIPE: The current video is replaced by the
new video, using the wipe pattern
selected in the Wipe menu.
DME: This applies a wipe-like transition,
using the DME effect selected in the
DME Wipe menu.
FM1&2CLIP, FM3&4CLIP,
FM5&6CLIP, FM7&8CLIP: A
recorded clip is played back together
with the transition. At this point, you
can also carry out a background
transition (wipe or mix (dissolve))
simultaneously together with the clip.
KF (key frame): Press this button, turning
it on, to enable using the fader lever as
a key frame fader.
b Key transition selection buttons
To insert or delete key 1 on the next
transition, hold down the [KEY1] button,
and select the type of transition using the
transition type selection buttons. If the key
is currently not inserted, the transition will
insert it, and if the key is currently inserted,
the transition will delete it. You can use the
[KEY2] button in a similar way.
While these buttons are held down, you can
select a key source with the cross-point
buttons on the key bus.
Pressing one of these buttons twice in rapid
succession changes the state of the
corresponding key bus so that a cross-point
can be selected.
c Transition execution section
Fader lever: Move this vertically to carry
out a transition.
When the [KF] button or a transition
type selection button to which the KF
button function has been assigned is lit,
you can use this as a key frame fader.
When the split fader function is
enabled, by pressing the projection on
the left side of the grip you can release
the lock and separate the two halves of
the fader lever. With the split fader
lever, in a background mix transition,
you can control the background A and
B buses independently.
Transition indicator: This comprises
multiple LEDs, which show the
progress of the transition.
Transition rate display: This displays the
transition rate (the time from the
beginning of the transition to its
completion) set for an auto transition,
in frames.
You can set the transition rate using the
numeric keypad control block or menu.
TAKE button: Pressing this button carries
out an auto transition of the set
transition rate. The transition starts
immediately, and the button lights
amber. When the transition completes,
the button goes off.
d Wipe direction selection buttons
For details, see “Wipe direction selection
buttons” (page 61).
e Pattern limit buttons
LIMIT SET: Move the fader lever to the
position of a particular pattern size, and
stop it there, then press this button to
set the pattern limit range. This button
is enabled when the [PTN LIMIT]
button is off.
PTN (pattern) LIMIT: When a wipe or
DME wipe is selected, pressing this
button, turning it on, enables the
pattern limit function.
f Key status display
For each of keys 1 and 2, when the key is
inserted, the corresponding ON indicator
lights. The OVER indicators show the
priority between keys 1 and 2, by lighting
when the corresponding key is on top. For
example, when key 1 appears over key 2 on
To Next Page
Loading...
