Maintenance 121
2005995 Rev O – 210712
9. Refill the syringe and repeat until the fluid coming out of the Purge Tube is clear and free
of ink.
10. Replace the Cap on the Printhead Purge Tube.
11. Move the waste ink receptacle underneath the Nozzle Face.
12. Refill the syringe with internal flush fluid.
13. Connect the other end of the tube to the Ink Line IN, and gently push the flush fluid
through the Ink Line IN. Ink and flush fluid will come out the Nozzle Face.
14. Refill the syringe and repeat until the fluid coming out of the Nozzle Face is clear and
free of ink.
Printhead
Pushing Ink Out the Purge Tube
Non-abrasive
Lint-Free Wipe(s)
Ink Line IN
Syringe
Waste Ink
Receptacle
Purge Tube
(uncapped)
Tube from
Appropriate
Flush Kit
Printhead
Pushing Fluid Out the Nozzle Face
Non-abrasive
Lint-Free Wipe(s)
Ink Line IN
Syringe
Waste Ink
Receptacle
Purge Tube
(capped)
Tube from
Appropriate
Flush Kit
To Next Page
Loading...
