Steris Reliance EPS Endoscope Processing System User Manual

6
6-1
Routine Maintenance Operator Manual 920011-649
6.1 General The sample routine maintenance guide included in this section
(Table 6-1) should be used as a guideline for determining the
frequency of routine maintenance. These will prove useful in
ensuring proper maintenance of your Reliance
™ EPS Endoscope
Processing System.
Maintenance procedures described in this section should be
performed as required at the suggested frequency. The
indicated frequencies are minimums and can be changed if the
Reliance
™ EPS Processor use warrants. If a problem occurs, refer
to SECTION 7, TROUBLESHOOTING.
Refer to S
ECTION 8, RECOMMENDED SPARE PARTS AND CONSUMABLE
PRODUCTS, of this manual for recommended spare parts list. Refer to
the Maintenance Manual (P764333-736) for complete replacement
parts list.
IMPORTANT: A listing of the Safety Precautions to be observed when operating and servicing this
processor can be found in S
ECTION 1 of this manual. Do not operate the equipment until you have become
familiar with this information.
WARNING – PERSONAL INJURY
AND/OR EQUIPMENT DAMAGE
HAZARD:
• Regularly scheduled preventive
maintenance is required for
safe and reliable operation
of this equipment. Contact
STERIS to schedule
preventive maintenance or
obtain the necessary
Maintenance Manual if
preventive maintenance is
done by the Customer.
• Repairs and adjustments to
this equipment must be made
only by STERIS or STERIS-
trained service personnel.
Nonroutine maintenance
performed by unqualified
personnel or installation of
unauthorized parts could
cause personal injury, result
in improper equipment
performance or result in
costly damage. Contact
STERIS regarding service
options.
WARNING – ELECTRIC SHOCK
AND/OR BURN HAZARD:
Disconnect all
utilities to
processor before servicing.
Do not service processor
unless all utilities have been
properly locked out. Always
follow local
electrical codes
and safety-related work
practices.
WARNING – ELECTRIC SHOCK AND/OR BURN HAZARD:
Pressing bottom portion of POWER (ON/OFF) toggle
switch to turn off processor DOES NOT cut off electrical
power. Lockout/Tagout building electrical disconnect
switch to turn off power to processor for maintenance or
repairs.
ROUTINE MAINTENANCE

Steris Reliance EPS Endoscope Processing System Specifications

General

Brand	Steris
Model	Reliance EPS Endoscope Processing System
Category	Laboratory Equipment
Language	English