v
Introduction Operator Manual 920011-649
Service Information A thorough preventive maintenance program is essential to help
ensure safe and proper processor operation. This manual contains
maintenance schedules and procedures which should be followed
for satisfactory equipment performance.
Customers are encouraged to contact STERIS concerning our
comprehensive annual maintenance program. Under the terms of the
program, preventive maintenance, adjustments and replacement of
worn parts are performed on a scheduled basis to help ensure
equipment performance at peak capability and to help avoid untimely
or costly interruptions. STERIS maintains a global staff of well-
equipped, qualified service technicians to provide this service, as well
as expert repair services. Please contact STERIS for details.
Trademarks Please take note of the following registered trademarks that apply to
the wording used throughout the manual:
• Fujifilm is a registered trademark of FUJIFILM.
• Olympus is a registered trademark of Olympus Optical Co., Ltd.
• Pentax is a registered trademark of Pentax Imaging Company.
Certification The Reliance EPS Processor meets the applicable requirements of
the following standards:
• Underwriters Laboratories (UL) Standard 61010-1, Third
Edition
• Canadian Standards Association (CSA) CAN/CSA C22.2
No. 61010-1, Third Edition.
The Reliance EPS Processor meets the following international
standards:
• ISO 15883-1 (2006): Washer-Disinfectors – General requirements,
terms and definitions and tests.
• ISO 15883-4 (2008): Washer-Disinfectors – Requirements and
tests for washer-disinfectors employing chemical disinfection for
thermolabile endoscopes.
Governing Directive for the affixing of the CE mark:
• Medical Device Directive 93/42/EEC as amended by 2007/47/EC.
Standards applied to demonstrate conformity to the directive:
• IEC 61010-1; IEC 61010-2-040; IEC 61326-1.
To Next Page
Loading...
Need help?
General
