Steris Reliance EPS Endoscope Processing System - Surfaces of Processor; Draining Holes and Punching Rods; Figure 6-2. Reliance CDS Draining Holes and Punching Rods

6-7
Routine Maintenance Operator Manual 920011-649
6.6 Surfaces of
Processor
The following cleaning procedures should be performed once per week:
1. Clean front of processor using a general purpose cleaner
(nonabrasive). Rinse with tap water and dry with a lint-free cloth.
2. Wipe all inside and outside plastic surfaces or painted surfaces
with a soft cloth dampened with 70% isopropyl alcohol or any
nonabrasive household cleaner (such as glass or countertop
cleaners). Rinse thoroughly with tap water and dry with a lint-free
cloth.
3. If processor is freestanding, clean countertop (optional) and side
enclosure panels using a general purpose cleaner (nonabrasive).
Rinse thoroughly with tap water and dry with a lint-free cloth.
4. Once a day, ensure there are no cleaner spills or drippage on
steel surfaces inside processor. If there are, clean steel surface
using a soft damp cloth. If a stain remains on steel surface,
slightly scrub stain using a scouring pad.
6.7 Draining Holes and
Punching Rods
1. Clean three draining holes at bottom of each control handle boot
using a thin wire (such as a paper clip) or compressed air.
2. Clean two draining holes at bottom of Reliance CDS using a thin
wire (such as a paper clip) or compressed air (see Figure 6-2).
3. Once a week, clean venting orifice of two Allen hex screws from
Reliance CDS as follows :
a. Remove two Allen hex screws from Reliance CDS (see
Figure 6-2).
b. Using compressed air, clean small orifice at center of each screw.
c. Reinstall two Allen hex screws on Reliance CDS.
4. Once a week, verify punching rods inside Reliance CDS are not
slack. Using a #2 Phillips head screwdriver, tighten three screws
under Reliance CDS.
CAUTION – POSSIBLE EQUIPMENT
DAMAGE: To ensure cleanliness
during operation and to avoid
damage to zinc-coated steel,
wipe any cleaner spills or
drippage inside Bag-in-a-Box
compartment. Clean any
surface that might have been in
contact with any cleaner inside
Bag-in-a-Box compartment.
WARNING – PERSONAL INJURY
AND/OR EQUIPMENT DAMAGE
HAZARD: When working with
compressed air, flying debris
and particles may present a
hazard to personnel in
immediate area. Personal eye
protection must be worn when
working with compressed air.
Allen Hex
Screw
Draining Hole
Punching Rods
Screws
Draining Hole
Allen Hex
Screw
Figure 6-2. Reliance CDS Draining Holes and Punching Rods