Steris Reliance EPS Endoscope Processing System - Performing Bar Code Test and Programming Operator and Physician ID Lists

5-16
920011-649 Operator Manual Cycle and Control Value Programming
47. Press ENTER touch pad to confirm selection. Display shows, for
example:
and printer records, for example:
===========================
HH:MM:SS XM MM-DD-YY
===========================
CYCLE - SINGLE
WITH WASHING
===========================
WASH
WATER TYPE HOT
TEMPERATURE XX.X C
RECIRC. TIME MM:SS
CHEMICAL KLENZYME
CONCENT. X mL/L
RINSE
WATER T
YPE HOT
RECIRC. TIM
E MM:SS
HLD
WATER TYPE HOT
TEMPERATURE XX.X C
GENERATION MM:SS
DISINFECTION MM:SS
RINSE 1
WATER TYPE HOT
RECIRC. TIME MM:SS
RINSE 2
WATER TYPE HOT
RECIRC. TIME MM:SS
AIR PURGE
RECIRC. TIME MM:SS
===========================
48. Once all modifications are complete, press ESC touch pad once
to exit Change Values menu. Display shows:
5.2.4 Performing Bar Code
Test and Programming
Operator and Physician ID
Lists
If bar code reader option is present, refer to SECTION 2, SERVICE
MODE PROCEDURE, in Maintenance Manual (P764333-736), for
procedures to perform a bar code test and program Operator and
Physician ID lists.
SINGLE
PRINTING
READY
MM-DD-YY HH:MM XM