Steris Reliance EPS Endoscope Processing System - Page 116

5-15
Cycle and Control Value Programming Operator Manual 920011-649
and printer records, for example:
========================
HH:MM:SS XM MM-DD-YY
========================
SUPERVISOR MODE
CONFIGURATION
========================
BAR CODE READER: YES
OPERATOR ID: YES
PATIENT ID: YES
DEVICE ID: YES
PROCEDURE ID: YES
PHYSICIAN ID: YES
0.2 μm FILTER
REMAINING DAYS: 90
WASHING SELECT: YES
REPEAT WASHING: YES
WATER SAMPLING: YES
CHEMICAL WARNING: YES
AUTOMATIC D-SHORT YES
LEAK TEST YES
NO
DUPLICATE PRINTOUT: YES
NO
QTY CYCLE PRINTS: X
EXTENDED PRINTS: YES
LANGUAGE: ENGLISH
FRA
NÇAIS
ESPANOL
OPERATORS LIST
————————
00001-NNNNNNNNNNNNNNNN
00002-NNNNNNNNNNNNNNNN
PHYSICIANS LIST
————————
00001-NNNNNNNNNNNNNNNN
00002-NNNNNNNNNNNNNNNN
========================
then, display shows:
__ blinking
44. Press SCROLL arrows (up or down) to enable (YES) or disable
(NO) PRINT CYCLES feature.
45. Press ENTER touch pad to confirm selection. Display shows:
__ blinking
46. Press SCROLL arrows (up or down) to scroll through cycle
names (SINGLE, DOUBLE, D-SHORT, D-LONG or ALL) to
select cycle values to be printed.
PRINT CYCLES
YES
SCROLL TO PRINT
SINGLE