1-2
920011-649 Operator Manual Safety Precautions
WARNING – ELECTRIC SHOCK AND/OR BURN HAZARD:
WARNING – BURN HAZARD:
WARNING – POSSIBLE FIRE HAZARD:
WARNING – CHEMICAL BURN AND/OR EYE INJURY HAZARD:
WARNING – EYE INJURY HAZARD:
WARNING – HEALTH HAZARD:
Fasteners and star washers are used to ensure protective bonding continuity. Always reinstall any star
washer which may have been removed during installation or servicing.
Pressing bottom portion of POWER (ON/OFF) toggle switch to turn off processor DOES NOT cut off
electrical power. Lockout/Tagout building electrical disconnect switch to turn off power to processor for
maintenance or repairs.
Allow piping to cool before inspecting and/or cleaning building supply-line strainers.
When processor is installed on a combustible floor, floor must be covered with a metal sheet extending
to outer edges of processor.
All personnel involved in the operation of this processor should be able to demonstrate the correct
procedure for disposal of Reliance dry chemistry containers.
CIP 200 Acid-Based Process and Research Cleaner is corrosive and can cause adverse effects to
exposed tissues. Do not get in eyes, on skin or swallow. Read and follow all precautions and instructions
on cleaner label and in Safety Data Sheet (SDS) prior to handling CIP 200 Acid-Based Process and
Research Cleaner Bag-in-a-Box container or servicing cleaner injection pump. Wear appropriate
Personal Protective Equipment (PPE) whenever handling detergent or servicing cleaner injection pump
and lines.
Klenzyme Enzymatic Presoak and Cleaner concentrate may cause serious damage to eyes. Product
may cause skin irritation. Do not get on skin or in eyes. Read and follow all precautions and instructions
on cleaner label and in Safety Data Sheet (SDS) prior to handling Klenzyme Bag-in-a-Box container or
servicing cleaner injection pump. Wear appropriate Personal Protective Equipment (PPE) whenever
handling cleaner or servicing cleaner injection pump and lines.
Laser radiation. Do not stare at bar code reader beam.
Before opening processor door manually, wear appropriate Personal Protective Equipment (PPE). Allow
processor to cool down. Avoid inhaling fumes from chamber and contact with any remaining solution.
To Next Page
Loading...
Need help?
General
