Stratasys Objet1000 Plus - Starting the Printer

Objet1000 Plus User Guide 6 Operating and Maintaining the Objet1000 Plus 3DPrinter
DOC-06810 Rev.B 6-2
Figure6-1TheObjet1000Plus3DPrinter
Starting the Printer
Caution
l DonotattempttooperatetheprinterbeforebeingtrainedbyaStratasys
CustomerSupportrepresentative.
l Observeallsafetywarningsandfollowthesafetyguidelinesdescribedin
Chapter2.
1. Turnonthemainpowerswitch,locatedatthebackoftheprinter.

Figure6-2Mainpowerswitch
Turningontheprinteralsoturnsonthetwobuilt-incomputers.