Stratasys Objet1000 Plus - Page 131

Objet1000 Plus User Guide 6 Operating and Maintaining the Objet1000 Plus 3DPrinter
DOC-06810 Rev.B 6-11

Figure6-9Printerinterfaceafterinterruptedprinting
5. If,foranyreason,thecorrectnumberdoesnotappearinthedialogbox,
enterthenumberandclickOK.
Youcannotcontinueprintingthemodelif:
•Thenumberofthelastsliceprinteddoesnotappearintheprinter
interface,eveniftheservercomputerdisplaystheContinue from Slice
confirmationdialogbox.
•Therewasarelativelylonginterruptioninprinting,evenifthe“lastslice”
and“continuefromslice”indicatorsarecorrect.Thepartofthemodel
alreadyprintedmaydeformorshrink,andtheremightbeavisible
differencebetweenitandthenewlyprintedpart.Theeffectsofaprinting
stoppageonamodeldependonthemodelsizeandstructure,Model
materialused,ambienttemperatureandthelengthofthestoppage.