Stratasys Objet1000 Plus - Page 132

Objet1000 Plus User Guide 6 Operating and Maintaining the Objet1000 Plus 3DPrinter
DOC-06810 Rev.B 6-12
Ifyoucannotcontinueprinting:
1. Cancelthejobintheprintingapplication(ObjetStudioorGrabCAD
Print).
2. Removethepartiallyprintedmodelfromthebuildtray.
3. Resendthejobtotheprinterfromtheprintingapplication.
❒ InObjetStudio,click .
❒ InGrabCADPrint,click .
Youcanstopprintingfromtheprinterinterfaceorfromtheprintingapplication
(ObjetStudioorGrabCADPrint).
•AfterclickingtheStopbuttonintheprintingapplication,youcanresume
printingfromtheprintingapplicationorfromtheprinterinterface.
•AfterclickingtheStopbuttonontheprinterinterface,youcanresume
printingonlyfromtheprintingapplication.
•AfterclickingthePausebuttonintheprinterinterface,youcanresume
printingonlyfromtheprinterinterface.