Stratasys Objet1000 Plus - Replacing Print Heads

Objet1000 Plus User Guide 6 Operating and Maintaining the Objet1000 Plus 3DPrinter
DOC-06810 Rev.B 6-47
❒ Ifthewizarddeterminesthataprintheadisfaulty—orthatitis
negativelyaffectingmodelqualitywiththecurrenthead
configuration—youneedtoreplaceit.Indicatewhetherornotyou
wanttodosonow.
Figure6-64Defectiveprintheadsfound
• SelectReplacedefectivehead(s)ifyouarepreparedtoreplacethe
printheadsnow(seebelow).
or—
• SelectAbortwizardifyouwanttoreplacetheprintheadsat
anothertime.
ReplaceprintheadsonlyafterconsultingwithaStratasys-authorized
customer-supportengineer.
Toreplaceprintheads,youneedthesetoolsandmaterials:
❒ replacementprinthead(s)
❒ isopropanol(IPA—isopropylalcohol)orethanol(ethylalcohol)
❒ disposablecleaninggloves(suppliedwiththeprinthead;oruseany
clean,powder-freeprotectivegloves)
❒ asuppliedcleaningclothorequivalent
❒ amirror
❒ a5-mmflat-headscrewdriverora3-mmhex(Allen)key(dependingon
thetypeofprintblock)
❒ thescalesuppliedforuseintheHeadOptimizationwizard(Weight
Test)
❒ theMissingNozzlesruler
Ifyouarereplacingprintheadsnow,thewizardguidesyouthroughthe
procedurewhenyouclickNext.Continuewith"ReplacingPrintHeads"on
thenextpage.